This course was created with the
course builder. Create your online course today.
Start now
Create your course
with
Autoplay
Autocomplete
Previous Lesson
Complete and Continue
Fusion 360
Day-1: Fusion 360 : Introduction to interface
Session-1 : Introduction to interface (126:05)
Day-2: Fusion 360 : Sketch to Extrude
Session-2 : Sketch to Extrude (70:29)
Day-3: Fusion 360 : Extrude to 3D Parameters
Session-3 : Extrude to 3D Parameters (41:28)
Day-4: Fusion 360 : Extrusion to modification command
Session-4 : Extrusion to modification command (48:52)
Day-5: Fusion 360 : Modify to construct
Session-5 : Modify to construct (85:10)
Day-6: Fusion 360 : Constraint ,Inspection, Insert and Selection
Session-6 : Constraint ,Inspection, Insert and Selection (60:50)
Day-7: Fusion 360 : Surfacing to modify
Session-7 : Surfacing to modify (51:43)
Day-8: Fusion 360 : Form feature to Modify
Session-8 : Form feature to Modify (86:08)
Day-9: Fusion 360 : Form modify to Utilities
Session-9 : Form modify to Utilities (74:12)
Day-10: Fusion 360
Session-10 (20:34)
Day-11: Fusion 360 : Assembly of Plummer Block
Session-11 : Assembly of Plummer Block (114:39)
Day-12: Fusion 360 : Assembly_2
Session-12 : Assembly_2 (67:32)
Day-13 Fusion 360 : Design To Drawing
Session-13 : Design To Drawing (106:12)
Day-14: Fusion 360 : Drawing_2
Session-14 : Drawing_2 (88:58)
Day-15: Fusion 360 : Revision about Form
Session-15 : Revision about Form (116:06)
Day-16: Fusion 360 : Practice Models
Session-16 : Practice Models (61:35)
Day-17: Fusion 360 : Rendering
Session-17 : Rendering (111:20)
Day-18: Fusion 360 : Animation to Generative Design
Session-18 : Animation to Generative Design (45:09)
Day-19: Fusion 360 : Generative Design
Session-19 : Generative Design (136:54)
Day-20: Fusion 360 : Generative Design_2
Session-20 : Generative Design_2 (84:28)
Session-12 : Assembly_2
Lesson content locked
If you're already enrolled,
you'll need to login
.
Enroll in Course to Unlock