This course was created with the
course builder. Create your online course today.
Start now
Create your course
with
Autoplay
Autocomplete
Previous Lesson
Complete and Continue
Fusion 360
Day-1: Fusion 360 : Introduction to interface
Session-1 : Introduction to interface (126:05)
Day-2: Fusion 360 : Sketch to Extrude
Session-2 : Sketch to Extrude (70:29)
Day-3: Fusion 360 : Extrude to 3D Parameters
Session-3 : Extrude to 3D Parameters (41:28)
Day-4: Fusion 360 : Extrusion to modification command
Session-4 : Extrusion to modification command (48:52)
Day-5: Fusion 360 : Modify to construct
Session-5 : Modify to construct (85:10)
Day-6: Fusion 360 : Constraint ,Inspection, Insert and Selection
Session-6 : Constraint ,Inspection, Insert and Selection (60:50)
Day-7: Fusion 360 : Surfacing to modify
Session-7 : Surfacing to modify (51:43)
Day-8: Fusion 360 : Form feature to Modify
Session-8 : Form feature to Modify (86:08)
Day-9: Fusion 360 : Form modify to Utilities
Session-9 : Form modify to Utilities (74:12)
Day-10: Fusion 360
Session-10 (20:34)
Day-11: Fusion 360 : Assembly of Plummer Block
Session-11 : Assembly of Plummer Block (114:39)
Day-12: Fusion 360 : Assembly_2
Session-12 : Assembly_2 (67:32)
Day-13 Fusion 360 : Design To Drawing
Session-13 : Design To Drawing (106:12)
Day-14: Fusion 360 : Drawing_2
Session-14 : Drawing_2 (88:58)
Day-15: Fusion 360 : Revision about Form
Session-15 : Revision about Form (116:06)
Day-16: Fusion 360 : Practice Models
Session-16 : Practice Models (61:35)
Day-17: Fusion 360 : Rendering
Session-17 : Rendering (111:20)
Day-18: Fusion 360 : Animation to Generative Design
Session-18 : Animation to Generative Design (45:09)
Day-19: Fusion 360 : Generative Design
Session-19 : Generative Design (136:54)
Day-20: Fusion 360 : Generative Design_2
Session-20 : Generative Design_2 (84:28)
Session-1 : Introduction to interface
Let's begin with our first session of training.
If you have any doubts, querries, questions about the session, you can ask them freely in comments.
Complete and Continue
Discussion
0
comments
Load more
0 comments